Connectors
-
Nwazet Key Lime Pi - Wire Scorpion
$11.1
The 'Pi Wire Scorpion' kit is designed to provide a practical enclosure for our 'Nwazet Key Lime Pi' breakout board. Use it as you build your project or as part of a final installation: it will do a great job at securing wires in place thanks to nine built-in zip-tie cutouts. The 'Pi Wire Scorpion' kit accommodates all the features of the 'Nwazet Key Lime Pi', works well with right-angle and straight pin headers and includes all the essential cables and connectors needed to complete your project quickly and neatly and your choice of premium jumper wires.
-
Stereo Cable
$1.95.jpg)
So, you're building a cool Internet radio player or streaming audio around the house using a Raspberry Pi? This cable is perfect when you need to output quality stereo sound and thanks to its right-angle jack, you'll be able to keep your build neat with the cord tucked-in closely to the computer.
-
GPIO Ribbon Cable for Raspberry Pi
$2.95
The Raspberry Pi is not just an inexpensive Linux computer, it also has a GPIO connector that enables lots of extensibility scenarios that are usually implemented on more conventional microcontrollers. Digital inputs and outputs, PWM, serial, I2C and SPI communication, as well as 5V and 3.3V pins are all supported on the 26-pin connector. It is not always practical however to connect directly there, especially if your Pi is in an enclosure such as our Pi Tuxedo Case.
-
JST Power Cable (2")
$0.25
This simple three wire cable, with its JST PH connectors, provides a clean and secure connection between, for example, our power supply, and your Pi-based projects when you need more than the 50mA that the GPIO connector can provide.
-
Ethernet Cable (Cat. 5, 350MHz, 10ft)
$2.35
This Ethernet cable can connect your 10Mbps, 100Mbps, or 1Gbps switch, router, or modem to a Raspberry Pi, or any compatible device. Its length of ten feet (approximately 3m) will fit the most common scenarios.
-
HDMI Cable (3ft.)
$3.5
This HDMI 1.3 cable is three feet long (about a meter) and will work perfectly with your Raspberry Pi.
-
Micro USB adapter
$2.15
This compact adapter bridges standard USB A and Micro USB female plugs, from a USB power supply to a microcontroller, Raspberry Pi or phone. Its two male plugs are the shortest path between power and your device, for those cases where a cable just won't do.
-
JST-PH Connector
$0.5
We use this through-hole, vertical insertion, JST connector on all of our Raspberry Pi products for board-to-board power. It provides reliable, shrouded contacts and is easy to solder.
-
Premium Jumper Wires (40x M/M, F/F, M/F)
$3.95
These premium jumper wires fit perfectly side-by-side into 0.1" pin headers or prototyping boards.
-
5cm go!cable
$2
These 5cm long cables will connect any Netduino Go module to your main board.